Skip to content
Serenity Plumbing CoRaleigh, NC plumbersAnswered 24/7(919) 557-9058

Backflow and water quality

Sump pump installation and repair for Raleigh crawl spaces

Water is standing in your crawl space or basement after a storm, the sump pump is silent or running nonstop, and more rain is on the way.

New sump pump in an encapsulated crawl space in Raleigh

First step on arrival: test the cycle

A sump pump sits in a pit at the lowest point of a crawl space or basement and pushes collected groundwater out and away from the house. When it works, nobody notices. When the float sticks, the motor burns out, the check valve fails or the power drops during a storm, water rises around footings, soaks insulation and encourages mold and wood rot under the floor.

Serenity Plumbing installs, repairs and replaces sump pumps in homes across Raleigh and the Triangle with its own plumbers, and we answer 24/7 for the nights when the pit is filling. We handle new pits in wet crawl spaces, pump replacements, check valves, discharge lines that freeze or clog, and battery or water-powered backups for homes that cannot afford a pump outage during a power cut.

Signs your sump pump needs work

Pump runs constantly

Nonstop running can mean a stuck float switch, a failed check valve letting water fall back, or a pump too small for the inflow.

Pump will not start

A silent pump with a full pit points to a tripped circuit, a jammed float, a burned motor or a blocked intake screen.

Short cycling

Turning on and off every few seconds wears out the motor and switch, and usually traces to the float or check valve.

Loud grinding or rattling

Grinding noises suggest a damaged impeller or debris in the pump, while banging on shutoff points to a missing check valve.

Water around the pit

Standing water in the crawl space while the pump runs means it cannot keep up, or the discharge line is blocked.

Pump over seven years

Many sump pumps wear out somewhere in the five to ten year range, so an older pump is worth testing before storm season.

How we fix and install sump systems

On a repair call, we pour water into the pit to watch the full cycle. That shows whether the float moves freely, whether the motor starts and pulls water down, and whether the check valve holds when the pump stops. We check the outlet and circuit, pull the pump to clean the intake screen, and look at the discharge line all the way to where it empties outside.

When a pump is worn out, we replace it with a cast iron or heavy-duty thermoplastic submersible sized to the water you actually get, with a vertical float that is less likely to hang on the pit wall. A new check valve and a union go on the discharge so the pump can be pulled later without cutting pipe. The discharge should end well away from the foundation, not at the base of the wall.

Sump Pump Installation & Repair work in a Raleigh home

For a new installation, we dig the pit at the low point, set a perforated basin on gravel, run the discharge out through the rim joist or foundation vent, and slope it to drain. A battery backup pump on its own check valve keeps running when storms knock out power. For homes where water is a constant problem, we work with your crawl space or drainage contractor on interior drains that feed the pit.

How the job goes

01

Test the cycle

We fill the pit with water and watch the float, motor, check valve and discharge through a complete pump cycle.

02

Find the failure

We check power, float movement, intake screen, impeller and discharge line to pinpoint why the system is not keeping up.

03

Repair or replace

Floats, check valves and discharge parts are repaired on the spot, or a correctly sized new pump is installed from the truck.

04

Add a backup

We can install a battery backup pump on its own discharge so the pit keeps draining when a storm takes out power.

05

Route the discharge

The outlet is extended and sloped so water lands well away from the foundation and does not cycle straight back into the pit.

Wet crawl spaces in the Triangle

Much of the Triangle sits on dense red clay that drains slowly and holds water against foundations. Many Raleigh homes are built on crawl spaces rather than full basements, especially in older neighborhoods like Glenwood-Brooklyn and Mordecai and in mid-century ranches across Garner and Cary. On lots that slope toward the house, heavy summer thunderstorms and the remnants of hurricanes can push groundwater into the crawl space faster than the soil can absorb it.

Encapsulated crawl spaces, now common in the area, usually include a sump pit under the vapor barrier, and those pumps get forgotten because nobody sees them. In winter, discharge lines left lying on the lawn can freeze during a hard cold snap and stop the pump from emptying. If your crawl space has pipes as well as water, our crawl space plumbing page covers the leaks we find down there.

What sump pump work typically costs

JobTypical range
Diagnosis and float or switch repair$137 to $264
Check valve replacement$163 to $297
Submersible pump replacement, 1/3 to 1/2 hp$487 to $873
Battery backup pump added$693 to $1,214
New pit and pump in a crawl space$1,287 to $2,346

Pump size and type, crawl space access and clearance, discharge length and whether a new pit is needed move the price most. A plumber gives the final figure after seeing the setup. See every range in our plumbing cost guide.

Questions about sump pump installation & repair

How do I know if my sump pump is working before a storm?

Pour a bucket of water slowly into the pit until the float lifts. The pump should start, pull the water down quickly and shut off cleanly without the pipe banging. Then go outside and check that water came out of the discharge. If nothing happens, or the pump runs but the level does not drop, it needs attention before the rain arrives.

Does a crawl space really need a sump pump?

Not every crawl space does. If yours stays dry through heavy rain, gutters and grading may be all you need. If water stands after storms, or the crawl space is encapsulated with a drainage system, a sump pump is what actually removes that water. Standing water under a house feeds mold and wood rot, so it is worth addressing early.

What happens to my sump pump when the power goes out?

A standard pump stops, which is a problem because storms that knock out power are often the same storms that fill the pit. A battery backup pump takes over automatically and can run for hours on a charged battery. In homes with city water and enough pressure, a water-powered backup is another option that needs no battery at all.

My crawl space is flooding right now. What should I do?

Stay out of standing water if any electrical equipment or outlets are near it. If the pump is plugged in and silent, check the breaker and the GFCI outlet. If it is running and losing ground, make sure the discharge outside is not blocked. Then give us a call at (919) 557-9058; we answer day or night and can usually get there quickly.

Plumbing problem right now?

Call and a person answers, day or night. A plumber from our downtown Raleigh office comes to you.

Call (919) 557-9058
Call (919) 557-9058 · 24/7