Fixtures and bathrooms
Appliance hookups for Raleigh kitchens and laundry rooms
You have a new dishwasher, refrigerator or washer sitting in the driveway, and the connections behind it need to be done right so nothing leaks into the floor.

First step on arrival: check existing connections
Delivery crews often set appliances in place but skip the plumbing, or connect them with whatever hose came in the box. A dishwasher needs a proper drain loop and a supply valve that actually shuts off. An ice maker line needs a solid connection and a shutoff you can reach. A washer needs hoses that will not burst and a drain that will not overflow.
Serenity Plumbing connects appliances in homes across Raleigh and the Triangle with its own plumbers. We install new shutoff valves when the old ones are seized, replace rubber hoses with braided stainless, add pans and leak sensors where they make sense, and connect gas ranges and dryers to existing gas lines. When a new line is needed, we run it on the same visit.
When to call before the appliance goes in
Seized shutoff valves
If the valve behind the old appliance will not turn or drips when moved, replace it before connecting anything new to it.
Rubber washer hoses
Original rubber washer hoses bulge and crack with age, and a burst hose can release a lot of water very quickly.
Saddle valve on ice maker
Self-piercing saddle valves clamped onto a copper line are a common leak source and should be replaced with a proper tee and valve.
No dishwasher drain loop
A drain hose lying flat on the cabinet floor lets dirty sink water flow back into the dishwasher tub after every rinse.
New location, no lines
Moving a refrigerator to an island or a washer upstairs means running new water, drain and sometimes vent lines to that spot.
Gas range or dryer
Switching from electric to gas, or connecting a new gas appliance, needs a properly sized line, a shutoff and a leak test.
How we connect each appliance
For dishwashers, we install a quarter turn shutoff under the sink, run a braided supply to the inlet valve, and route the drain hose with a high loop or air gap into the disposal or sink tailpiece. If it drains through a new disposal, we confirm the knockout plug is removed. Then we level the unit, secure it to the counter or cabinet sides, and run a full cycle to check for drips.
Refrigerators with ice makers and water dispensers get a dedicated shutoff, a braided stainless or copper line with enough slack to pull the fridge out, and a check for kinks behind the unit. For washers, we replace the outlet box valves if needed, connect braided hoses, and confirm the standpipe drains fast enough to keep up with the pump. Upstairs laundry rooms get a drain pan piped to a safe spot.

Gas appliances get a new flexible connector, a shutoff within reach, and a leak test on every fitting with a gas detector and soap solution. If the range or dryer needs a gas line where none exists, we size and run it from the existing system. We do not reuse an old flexible gas connector, because its fittings deform once tightened and manufacturers advise against reinstalling them.
How the job goes
Check existing connections
We look at the shutoff valves, drain, outlet box and gas line already in place and note anything that needs replacing first.
Replace weak parts
Seized valves, saddle valves, rubber hoses and old gas connectors are swapped out before the new appliance is hooked up.
Connect and secure
Supply, drain and gas lines are connected with the right fittings, and the appliance is leveled and anchored where the manufacturer requires it.
Leak test
We pressurize every water connection and test every gas fitting, then watch the joints while the appliance runs its first cycle.
Show the shutoffs
Before leaving, we show you where each appliance's shutoff valve is so anyone in the house can stop a leak quickly.
Hookups in Raleigh area homes
Plenty of homes built in north Raleigh, Wake Forest and Morrisville through the 1990s and 2000s put the laundry room on the second floor. That is convenient until a hose fails, and then water comes through the kitchen ceiling. A washer pan piped to a drain, braided hoses and an automatic shutoff valve are inexpensive protection in those layouts. We also find many fridges still connected with the saddle valve installed when the house was built.
In older Raleigh homes around Mordecai and Cameron Park, kitchens have often been remodeled several times, and the shutoffs under the sink can be decades old and frozen in place. In crawl space houses, ice maker lines sometimes run through the floor, which exposes them to winter freezes. If you are adding a gas range where there is no line yet, we handle gas line installation to the kitchen as part of the same visit.
Typical appliance hookup pricing
| Job | Typical range |
|---|---|
| Dishwasher hookup with new shutoff | $187 to $326 |
| Ice maker line with proper tee and valve | $143 to $268 |
| Washer hookup with braided hoses | $118 to $214 |
| Washer outlet box replacement | $287 to $496 |
| Gas range or dryer connection and leak test | $167 to $293 |
| Upstairs washer pan with drain line | $238 to $467 |
Prices move with whether old valves must be replaced, how far a new line has to run, and access behind the cabinets or appliance. A plumber confirms the actual price on site. See every range in our plumbing cost guide.
Questions about appliance hookups
Does the dishwasher drain need a high loop or an air gap?
One or the other, depending on your setup and local rules. The purpose is the same: keep sink water from draining back into the dishwasher. A high loop secures the hose up under the counter before it drops to the disposal or tailpiece. An air gap is a small fitting on the sink deck. We install whichever fits your kitchen and what the local inspector expects.
How often should washing machine hoses be replaced?
A common recommendation is every five years for rubber hoses, sooner if they show bulging, cracking or rust at the crimped ends. Braided stainless hoses last longer, but they still have rubber inside and should be checked whenever you move the machine. Turning off the washer valves before a long trip is a smart habit.
Can you connect a refrigerator that is far from the sink?
Yes. We run a new water line from the nearest cold supply, through the cabinets, wall or crawl space, and install a dedicated shutoff near the refrigerator. In slab homes the line usually travels through base cabinets or the wall. We avoid routes where it can freeze or be crushed, and we leave enough coiled slack to pull the fridge out for cleaning.
Will you install the appliance or only the plumbing?
We handle the plumbing and gas connections and set the appliance in place when it is a typical dishwasher, range, washer or refrigerator. Electrical work beyond plugging into an existing outlet goes to an electrician. If you are not sure what your new appliance needs, give us a call at (919) 557-9058 with the model number and we will tell you.
Related
Related plumbing services
Gas Line Installation
You picked out a gas range, a tankless heater or an outdoor grill, and now there is no gas line where the new appliance...
Learn moreGarbage Disposal Repair & Installation
Your disposal hums but will not spin, trips its reset button, or leaves a puddle in the sink cabinet, and the kitchen...
Learn moreMain Shut-Off Valve Replacement
A pipe is leaking and the main water valve will not turn, only turns partway, or drips from the stem every time you...
Learn moreLeak Detection
Your water bill jumped, the meter keeps spinning with everything off, or a patch of floor feels damp, but there is no...
Learn morePlumbing problem right now?
Call and a person answers, day or night. A plumber from our downtown Raleigh office comes to you.