Skip to content
Serenity Plumbing CoRaleigh, NC plumbersAnswered 24/7(919) 557-9058

Pipes, water and gas lines

Gas leak repair for Raleigh homes after the utility clears it

You noticed a rotten egg odor near the water heater or the yard, the utility shut off the meter, and now the house has no heat or hot water.

Testing a gas pipe union for leaks beside a water heater

First step on arrival: safety first

If you smell gas right now, stop reading. Leave the house, leave the door open behind you, and do not flip switches, unplug anything or use a phone indoors. Once outside and away from the house, call your gas utility or 911. For most of the Triangle that is Dominion Energy / PSNC, now operating as Enbridge Gas North Carolina. They respond to odor calls and make the area safe.

Once the utility has shut off or tagged the system, the leak on your side of the meter is yours to have repaired. That is where Serenity Plumbing comes in. We find the leaking joint, valve or connector, repair it, pressure test the whole system, and relight the appliances so the utility can restore service. We answer 24/7, so call (919) 557-9058 after the utility has cleared the house.

Signs of a gas line problem in your home

Rotten egg smell

Utilities add a sulfur odor to natural gas so leaks are noticeable, so treat any such smell as a real leak.

Hissing near piping

A faint hiss near the meter, a valve or an appliance connector can mean gas is escaping under pressure.

Dead patch in the yard

A strip of brown grass or dying shrubs along a buried gas line route can point to a leak underground.

Bubbles in wet soil

After rain, steady bubbling in a puddle over a buried line is a warning sign worth reporting to the utility.

Yellow or lazy flames

Burners that turn yellow, flicker or lift off the ports can signal a supply problem or a combustion issue.

Red tag on the meter

If the utility locked or tagged your meter, they found a problem and need repairs before service comes back.

How Serenity repairs a leaking gas line

We arrive after the house is safe, with the meter off or the affected section isolated. The first job is finding exactly where the leak is. We test joints, unions and valves with leak detection solution and an electronic gas detector, working from the meter toward each appliance. Old flexible appliance connectors, loose unions on water heaters, and corroded fittings in damp crawl spaces are the usual culprits.

Most indoor repairs mean replacing a fitting, a failed shutoff valve or an old connector. Uncoated brass connectors from decades past are replaced outright rather than tightened. If we find black iron pipe rusted through under a house, we replace that section and recommend protecting the rest. For a buried line leaking in the yard, we locate it, mark utilities through NC 811, and dig to the leak or run a new line around it.

Gas Line Repair work in a Raleigh home

After the repair, the system gets a pressure test and must hold. Then we purge air from the lines, relight every pilot or ignite every appliance, and check that each one burns properly. We also walk you through where your shutoff valves are. If the utility needs to turn the meter back on, we tell you the repair is done so you can call them, and we stay available while service is restored.

How the job goes

01

Safety first

You leave the house and call the gas utility or 911 from outside. We come after the system is shut off and safe.

02

Find the leak

We test every joint, valve and connector with solution and an electronic detector, from the meter toward each appliance.

03

Repair the fault

Failed fittings, valves, connectors or rusted pipe sections are replaced with new parts suited to that location and pipe type.

04

Pressure test

The repaired system is pressurized and must hold steady before anyone turns the gas back on to the appliances.

05

Relight appliances

We purge the lines, relight the furnace, water heater and range, and check that each one burns cleanly.

Why gas lines fail in Triangle homes

Humidity under crawl space homes is hard on steel. Black iron gas pipe running a few inches above damp red clay can rust from the outside over the decades, especially where vapor barriers are torn or missing. We see this often in older homes around Raleigh and Durham. Older water heaters and furnaces may also still have flexible brass connectors that predate current coated designs.

Outside, buried yard lines to grills, pool heaters and detached garages take damage from fence posts, landscaping and new irrigation. Tree roots can shift a line over time. Remnants of hurricanes and big summer storms sometimes topple trees whose root balls pull up buried lines. When that happens, we repair the damaged section after the utility has made the area safe and the tree is cleared.

What gas line repair usually costs

JobTypical range
Leak locating and system pressure test$187 to $428
Replace appliance connector and valve$214 to $467
Replace a leaking fitting or union$263 to $618
Replace a rusted section under the house$687 to $1,543
Buried yard line repair or reroute$894 to $2,368

Leak location, access, and whether more than one fault turns up during testing affect the price. A plumber confirms the figure once the leak is found. See every range in our plumbing cost guide.

Questions about gas line repair

Should I call a plumber or the gas company first?

Call the gas utility or 911 first, from outside the house. Their job is to stop the danger right away, and they respond to odor reports at any hour. Our job comes next: once the system is shut off and safe, we find and fix the leak on your side of the meter so the utility can turn your service back on.

Why was my meter locked after the utility visit?

When the utility finds a leak on the homeowner's piping, they usually shut off and lock or tag the meter so gas cannot flow until a repair is made. That is normal. After we repair the leak and the system passes a pressure test, you call the utility, and they return to release the meter and restore service.

Is a faint gas smell near the outdoor meter normal?

A very brief whiff when an appliance first starts can happen, but a smell that lingers around the meter or regulator is not normal and should be reported. The utility owns the meter and regulator, so leaks there are theirs to repair. If they find the meter is fine and the leak is on your house piping, that part is ours.

Can an old gas connector behind my dryer be dangerous?

It can. Older uncoated brass connectors were made before current designs, and some develop cracks or fail at the flare fitting, especially if the appliance gets pushed around. If your dryer, range or water heater has a thin unpainted metal connector, have it replaced with a new coated one and a fresh shutoff valve. It is a small job.

Plumbing problem right now?

Call and a person answers, day or night. A plumber from our downtown Raleigh office comes to you.

Call (919) 557-9058
Call (919) 557-9058 · 24/7