Drains and sewer
Adding an outdoor sewer cleanout to Raleigh homes that lack one
The main line backed up and the plumber had to pull a toilet or climb onto the roof to reach it, because your house has no usable sewer cleanout.

First step on arrival: find the building drain
A sewer cleanout is a capped pipe that gives direct access to the main drain line. With one in the right place, a plumber can clear a clog, run a camera or relieve a backup from outside the house, without pulling a toilet or working through a roof vent. Many older Raleigh homes were built without an exterior cleanout, or have one buried under mulch, paved over or broken off by a mower.
Serenity Plumbing installs single and two-way cleanouts on the main sewer line, usually just outside the foundation where the building drain leaves the house. A two-way fitting lets us send a cable or camera toward the street or back toward the house from the same opening. It is one of the less expensive sewer improvements you can make, and it pays off the next time a main line clog hits.
Signs your home needs a sewer cleanout added
Toilet pulled for every clog
Each main line clog means removing a toilet, which adds time, a new wax ring and mess on the bathroom floor.
No cap anywhere outside
You have walked the foundation and found no capped pipe near where the sewer leaves the house toward the street.
Cleanout buried or paved
An old cleanout sits under a patio, a planting bed or concrete, so nobody can actually open it during an emergency.
Cracked or missing cap
A broken cap lets in soil, rainwater and small animals, and a riser clipped by a mower can crack below grade.
No outside access point
Sewage rises in a tub or shower during a backup because there is no outside opening where we can relieve it quickly.
Sewer work already planned
A repair, replacement or lining job is a good time to add cleanouts, since the line is already exposed or being filmed.
How we install a sewer cleanout
We start by finding the building drain where it leaves the foundation. In crawl space homes, that is usually visible under the house; on slab homes, we locate it with a camera and transmitter sent from inside. Then we choose a spot just outside the wall that will stay accessible, away from downspouts and out of the main mower path, where a cap can sit flush or slightly above grade.
With the pipe exposed, we cut in a cleanout fitting, either a single wye pointing toward the street or a two-way fitting that opens in both directions. The riser comes up to grade in the same diameter as the line, usually 4 inch, and finishes with a threaded cap, or a heavier cover where foot traffic or a driveway is involved. Connections to clay or cast iron use shielded couplings.

Before backfilling, we run water and push a camera through the new opening to confirm clean flow in both directions. The finished cleanout is noted on a simple sketch for your records. Pair it with regular drain cleaning and future service visits go faster and cost less. If your line is backed up today and there is no cleanout, call (919) 557-9058; we answer 24/7 and can install one as part of the clearing.
How the job goes
Find the building drain
We trace where the main drain leaves the house, from the crawl space or with a camera and locator on slab homes.
Pick the spot
The location balances code, easy access and your yard layout, avoiding downspouts, walkways and areas where water pools after rain.
Dig and expose
A small hole exposes the sewer pipe outside the foundation, with hand digging near gas, irrigation and buried power lines.
Cut in the fitting
We install a single or two-way cleanout fitting, bring the riser to grade, and seal every joint for a gas-tight connection.
Test and finish
Water and a camera confirm flow in both directions, then we backfill, set the cap and tidy the work area.
Why so many Triangle homes are missing cleanouts
Older houses in Glenwood-Brooklyn, Mordecai and the streets off Hillsborough Street were built before exterior cleanouts were standard practice, and many rely on an interior cleanout in a crawl space or basement that may be painted shut or hard to reach. Even where one exists outside, years of mulch, ivy and regrading have often buried it. We spend a fair amount of time on service calls simply finding the old access point.
Newer homes in Wake Forest, Rolesville and Holly Springs usually have a cleanout, but it is often a thin plastic riser near the front walk that gets clipped by mowers or edgers and quietly fills with dirt. We also see cleanouts set too low after sod was laid, so rain runs straight into them. Raising, replacing or adding a second cleanout is a small job that prevents a much messier one.
Typical cleanout installation prices
| Job | Typical range |
|---|---|
| Locate the building drain (camera and transmitter) | $163 to $319 |
| Single cleanout, shallow pipe in open soil | $487 to $893 |
| Two-way cleanout outside the foundation | $637 to $1,186 |
| Deep line or cleanout next to concrete | $1,083 to $1,947 |
| Replace a damaged cap or riser | $118 to $286 |
Depth of the pipe, the pipe material and what covers the work area set the price. Your plumber confirms the actual cost on site before any digging starts. See every range in our plumbing cost guide.
Questions about sewer cleanout installation
What is the difference between a single and a two-way cleanout?
A single cleanout opens in one direction, usually toward the street, which covers most clogs. A two-way fitting opens both toward the street and back toward the house, so a camera or cable can reach the building drain as well as the lateral from one spot. For homes with recurring clogs, the two-way design is often worth the small extra cost.
Can a cleanout go inside the crawl space instead of the yard?
It can, and many older homes already have one there. The trouble is reach and mess: working a cable through a crawl space opening is slower, and a backup there spills under the house. An exterior cleanout near the foundation is easier to use and keeps any overflow outside. Some homes benefit from having both.
My cleanout cap is cracked. Is that urgent?
It is worth fixing soon. A cracked cap lets rainwater into the sewer, along with soil and debris that can start a clog, and it can let sewer gas and odor out near your door. Replacing a cap is quick and inexpensive. If the riser below it is cracked too, we replace that section while we are there.
Will adding a cleanout lower what I pay for future drain calls?
Usually. Without one, a plumber may need to pull a toilet, reset it with a new wax ring, or work from a roof vent, and each of those adds time. With a properly placed cleanout, clearing or filming the main line starts right away at ground level, so visits tend to be shorter and simpler.
Related
Related plumbing services
Main Line Clog Clearing
Sewage is coming up in the lowest tub or shower, toilets gurgle when the washer drains, and every fixture in the house...
Learn moreDrain Cleaning
The kitchen sink holds water after the dishes, the shower drains around your ankles, or one bathroom keeps clogging no...
Learn moreSewer Camera Inspection
You are buying an older home, a sewer line keeps backing up, or you have been told the line needs replacing and want to...
Learn moreSewer Line Repair
Sewage is backing into a tub or floor drain, or the cleanout cap is weeping, and the line between your house and the...
Learn morePlumbing problem right now?
Call and a person answers, day or night. A plumber from our downtown Raleigh office comes to you.